Overwing emergency exits are found on passenger aircraft to provide a means of evacuation onto the wing, where passengers continue off the trailing edge, either by sliding down the extended Flaps or by using an evacuation slide that deploys when the exit is opened.
Overwing exits are smaller in width and height than standard on an aircraft, and therefore have a reduced evacuation capacity, and are typically added to aircraft where there is insufficient evacuation capacity at the main doors to obtain a 90 second evacuation, but where the addition of another set of full sized exits is not necessary to accomplish this.
Overwing exits are primarily self-help exits meaning that in an emergency evacuation the passengers seated immediately adjacent to the exit will be responsible for assessing external hazards and opening the exit. Thus, airlines normally restrict seating in these rows to people who are physically capable of assisting in an evacuation, and are not flying with children or other passengers that they may need to assist.
Another hazard in the use of overwing exits is their being improperly opened, usually a result of passengers in these seats not paying attention to the verbal briefing provided pre-departure, or not observing the opening instructions on the safety card and on the exit. The majority of overwing exits involve the passenger physically removing the hatch from its frame and disposing of it outside on the wing without blocking the exit. Research conducted at the Cranfield Institute in the UK showed that many passengers are prone to leaving the exit hatch on the seat next to the exit, thereby hindering other passengers' egress through the exit.
Additionally, during aircraft evacuations, it has been found that the majority of overwing window exit designs of Boeing 737 (NG) Next Generation Line along with the Airbus A320, hamper evacuation in comparison with traditional floor level exits due to the inherent "step up and through motion" required of passengers as they exit the aircraft, unlike the designs of older generation wide body aircraft such as the Boeing 747, Boeing 777, McDonnell Douglas DC-10 and Lockheed L1011 which are all floor level.
Depending on the height of the aircraft from the ground, an overwing exit may have an automatically inflating slide that is housed within the fuselage near to the exit(s). If the exit is opened the slide will automatically deploy and inflate to provide a means of evacuation from the wing to the ground. Only the slide and emergency lighting on the same side of the aircraft as the open hatch will operate. However, on aircraft where there is a pair of adjacent overwing exits on both sides of the aircraft (i.e. four in total), such as on some Boeing 767-300 variants, opening one of the pair of doors will deploy the slide. Should slide inflation fail, there is a manual inflation handle within the door frame of each exit (the location of which varies but is always indicated on the safety information card) which can be pulled to inflate the slide. Should this also fail, sliding down the extended flaps on the rear of the wing is possible.
|
|